The ISO1176T is a 40Mbps, half-duplex, isolated RS-485 and RS-422 transceiver with integrated transformer driver

The ISO1176T is an AN5273 isolated differential line transceiver with an integrated oscillator output that supplies the primary voltage to the isolation transformer. The device is ideal for long transmission lines because the ground loop is broken, allowing the device to operate over a wider range of common-mode voltages.

The symmetrical isolation barrier of each device is tested to provide 4242V PK of isolation for 60 seconds per VDE between the line transceiver and the logic level interface.

A Galvanically Isolated Differential Bus Transceiver is an integrated circuit designed for bidirectional data communication on multipoint bus transmission lines. The transceiver combines galvanically isolated differential line drivers and differential input line receivers. The driver has an active high enable with an isolated enable status output on the ISODE pin (pin 10) to facilitate directional control. The driver differential output and receiver differential input are internally connected to form a differential input/output (I/O) bus port designed to provide minimal loading to the bus when the driver is disabled or V CC2 = 0.

Any wired I/O can be affected by electrical noise transients from various sources. If these noise transients are of sufficient magnitude and duration, they can damage the transceiver and/or nearby sensitive circuitry. The ISO1176T can significantly reduce the risk of data corruption and damage to expensive control circuits.

The device is characterized for operation over an ambient temperature range of –40°C to 85°C.

characteristic:

Meets or exceeds the requirements of EN 50170 and TIA/EIA-485-A

●Signaling rate up to 40 Mbps

Simple isolated power supply design with integrated transformer driver

Typical efficiency > 60% (I LOAD = 100 mA) - see SLUU471

●Differential output exceeds 2.1V (54Ω load)

Low bus capacitance 10 pF (max)

Fail-safe receiver for bus open, shorted or idle

50kV/μs typical transient immunity

● Safety and regulatory approvals

○4242 V PK basic insulation according to DIN V VDE V 0884-10 and DIN EN 61010-1

○ 2500 V RMS isolation for 1 minute per UL 1577

○CSA Component Acceptance Notice 5A, IEC 60950-1 and IEC 61010-1 Standards

application:

●Factory automation

●Networked sensors

● Motor/Motion Control

●HVAC and building automation networks

●Network Security Station

parameter:

Type: RS-485

Data Rate (Max) (Mbps): 40

Isolation Level (Vrms): 2500

Surge Voltage Capability (Vpk): 4000

Operating temperature range (°C): -40 to 85

ISO1176T typical application

ISO1176T functional block diagram